Meyer MDV Series Manual de Instruções descarregar pdf (Página 7)

INSTALLATION, OPERATING INSTRUCTION AND PARTS MANUAL

MDV SERIES







1. Hydraulic components should be kept as clean

as possible during assembly operations.

2. Galvanized pipe and pipe fittings must not be

used because flaking of galvanizing material can

cause damage to major hydraulic components.

3. A pipe joint sealant, compatible with hydraulic oil,

must be applied to all NPT fittings. Teflon tape is

not recommended. Do not apply pipe joint

sealant to ORB or JIC fittings.

4. Hose should be protected where severe wear may

be caused by vibration or sliding movement.

5. Long runs of hose should be supported by tie

wiring or clamping.

6. Pressure and return hoses, connected to hydrau-

lic motors, may be reversed for proper motor

rotation. Spinner rotates in a clockwise direction

when looking down from top.

7. Use hose manufacturers recommendations for

fitting reusable hose ends.

8. Hydraulic pumps must be mounted so shaft

rotates in direction of arrow.

9. Locate reservoir as close to pump as possible. It

may be installed on truck frame or truck box.

10. Hydraulic return line filter is screwed directly onto

reservoir with cartridge down. Oil must flow

through filter in direction of arrow on filter.

11. Install the quick connect couplings so that when

disconnected, there is a male and female on the

truck as well as on the spreader. This way hoses

will always be hooked up properly, and hose ends

can be coupled together when spreader is in

storage to prevent system contamination.

12. See page 9 for valve assembly.

13. Operate hydraulic system for several minutes to

warm up. Check all connections for leaks.

14. After running, refill reservoir to three-fourths full.





     









Good Grade of MS10W Hydraulic Oil which has

wear, oxidation and foam inhibitors.

10 Micron Element Return Line Filter

1500 PSI

0 - 10 GPM - With single flow valve connect

conveyor and spinner in series.

0 - 15 GPM - With dual flow valve connect separate

pressure line to conveyor and spinner motor.

*Hydraulic Oil -----------------------------

*Oil Filter -----------------------------------

*Relief Valve Setting ---------------------

*Oil Flow -----------------------------------

00122-588-03 NOVEMBER 2009

PAGE 7

1 2 3 4 5 6 7 8 9 10 11 12 ... 75 76

Comentários a estes Manuais

Sem comentários

Meyer MDV Series Manual de Instruções Página 7

Comentários a estes Manuais

Manuais e produtos relacionados com Espátula Meyer MDV Series