
INSTALLATION, OPERATING INSTRUCTION AND PARTS MANUAL
MDV SERIES
2. Attach or lower spinner assembly.
3. Position the spreader in the truck bed, just short of mak-
ing contact with the rear most part of the truck bed, bumper,
pintle hook etc. Bolt the unit to the truck using a minimum of
four (4) 1/2” Grade 5 bolts and corresponding washers and
locknuts. The spreader is designed to sit at on the bed of the
truck, supported by the longitudinal
sides.
4. Material could freeze causing the unit to not function cor-
rectly. Hopper should be emptied and cleaned after each use.
5. Attach the hold down at each corner of the hopper as
shown on page 5. Locate and drill four .531(17/32”) diameter
holes for eyebolts in the truck bed. Straps must be positioned
at opposing angles so that the spreader cannot slide forward
or rearward. Assemble ratchet/strap to eye bolts. Tighten
hold downs evenly. Do not overtighten,
damage will result to the spreader or the truck.
The Meyer MDV
TM
Spreader can be mounted and stored
as a single unit. The Meyer MDV
TM
Spreader will mount on
most 15,000 to 20,000 GVW and larger trucks.
It is quite possible to overload the vehicle by improperly
mounting or overloading the spreader. This could result in
dangerous stability and braking problems. Always consult
and follow the truck manufacturer’s instructions.
1. Place the spreader in the rear of the truck with the en-
gine/motor to the rear of the truck. Center the spreader(side
to side) in the truck.
3
NOVEMBER
PAGE 4
Comentários a estes Manuais