Meyer MDV Series Manual de Instruções descarregar pdf (Página 12)

INSTALLATION, OPERATING INSTRUCTION AND PARTS MANUAL

MDV SERIES





The wireless controller is a compact unit with two parts. One part is the Base Unit (Receiver) and the

other part is the Transmitter (Hand Held Controller). The Transmitter is used to send a corresponding

signal to the Base Unit to act as a remote switching device.



The Swenson Wireless Controller comes factory programmed. That means matching the Base Unit to

the Transmitter has been done by Swenson Spreader. This gives a matched (1 of 16 million combinations

@ 418MHz) interface between the Transmitter and Base Unit. See Figures 1 & 2 for Transmitter button

assignments. On the 8 button Swenson Spreader Transmitter, all (8) buttons are used when programming.

When programming is completed, only (5) buttons are functional (Buttons #1, #3, #4, #5, & #6) (see Fig.

1).

Fig. 1: Transmitter Front Button Assignments

Fig. 2: Transmitter Back Button Assignments

Button #7 (open button)

utton #1 (clutch on/off)

Button #8 (open button)

Button #2 (open button)

Button #3 (Throttle decrease)

Button #4 (Throttle increase)

& “Hold to Choke

”

Button #6 (engine off)

Button

5 (engine start)

“

ADD” Button

depress with paperclip

“blue” LED

3        NOVEMBER 

PAGE 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 75 76

Sem comentários

Meyer MDV Series Manual de Instruções Página 12